Emergency DC UPS
Magellan’s emergency DC UPS is a complete solution for avoiding any loss of DC power in substations. The unit is light, compact and portable. It combines an advanced, integrated, reliable battery charging system and light weight, high efficiency Lithium batteries, along with an integrated intelligent battery monitoring system (BMS).
The charger operates from 240VAC, providing dual uninterruptible 110VDC and 24VDC or 48VDC power. The unit is to be kept connected to mains at all times when it is not being used to make sure that the batteries are charged and are available at full capacity when needed. Then this portable DC UPS allows technicians to restore the site DC power without stress.
Compact and portable design.
Complete solution for avoiding DC
Uses light-weight, high efficiency lithium
batteries with removeable modules.
Easy to deploy/ portable.
Provides dual DC output power,
110V/20A and (24V/25A or 48V/25A).
Allows technicians to restore site DC
power without stress.
Electronic Load Bank
The Electronic Load Bank is specially designed for discharge experiments, battery capacity tests, battery maintenance, engineering examination and other tests for DC power with load. It covers a wide range of voltages from 10VDC to 127VDC (nominal voltage: 24VDC - 48VDC - 110VDC). This makes it applicable for battery discharge in different areas of application. With it’s optional Data Acquisition Case (DAC), you will have real-time monitoring for the whole process of discharge with wireless communication in PC.
User friendly and easy to use interface.
Small, lightweight, compact and portable.
Optional Wireless DAC enables real-time PC monitor for battery cell voltage measurement.
Continued discharge available.
Parallel connection of two units for higher discharge current.
Works with other load banks for assistant discharge.
Can monitor measurement of other load banks or battery chargers.
Safe circuits protect battery during measurement.
Powerful management software for data analysis and report printing.
Automatic protection upon over-heating and overload.
Australian designed and manufactured, the Emergency Charger is an invaluable tool for keeping substation batteries in a charged state and keeping down time to zero. In case of a substation charger failure, simply connect the Emergency DC Power Supply to the batteries and your charger can be repaired without time pressure.
High efficiency switch-mode technology.
Unity power factor.
Low cost, maintenance free.
Analog voltmeter and ammeter.
Adjustable output voltage.
Compact and light weight.
Can be used on lead acid and NiCad batteries.
Highly reliable and easy to connect.